GnuTLS fatal error on push from local commandline to remote Gitea

First try at pushing a local repo up to the new Gitea remote and I get this error :

fatal: unable to access ‘’: GnuTLS recv error (-110): The TLS connection was non-properly terminated.

Could be my config. Any suggestions on troubleshooting?

Are you using the builtin SSH server? Are you plugging to OpenSSH? Does SSH work normally when you access your server?

The Gitea server is behind an Nginx reverse proxy so I currently only have port 443 forwarded. I don’t have SSH port forwarded though I could, instead I SSH into the host and SSH onto the Gitea container from there. SSH works fine this way. I was trying to see it work purely over https for the webgui first. Is that possible to work with Gitea?

I want to bump this thread again. - I think I only have a small problem, either with my config or my understanding. I am new to git in general so not entirely sure what I’m doing.

I know it’s not anything serious because I can migrate from the github /githubtraining/basic-example into my gitea server and it works perfectly first time.

Then when I make a new repository and follow the commands shown on the page:

Pushing an existing repository from the command line

git remote add origin
git push -u origin master

The first command completes without any response. The second command fails with the error message:

fatal: unable to access ‘’: GnuTLS recv error (-110): The TLS connection was non-properly terminated.

My Gitea server is in a container behind an NginX reverse proxy. I now have SSH direct to the container by iptables port forward from the WAN IP address but I cannot push using SSH as the user ‘git’ does not have login rights. I built the installation following these instructions, on an NginX hosting system I already had.

Any help gratefully appreciated! Thanks

@howl Thanks for your reply, sorry I didn’t answer specifically before. The debian container server that gitea is installed in has SSH and I can access it normally.

I think so - I am using the SSH server in the debian container where gitea is installed.

ssh -V

gives -:

OpenSSH_6.7p1 Debian-5+deb8u3, OpenSSL 1.0.1t 3 May 2016